Flying Gadgets T41 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Juguete Flying Gadgets T41. Flying Gadgets T41 6 páginas. F-series 4 ch digital proportional r/c

Imprimir página

Hints

If the helicopter keeps self-rotating in the air even there is no control signal given, you could correct

it by adjusting the trimmer of gyro on the remote control.

Videography and Photography Function

1. Insert the TF memory card into the videography module of the helicopter and turn on the

helicopter by push the power switch. At this time, the red light and the green light keep flashing

in turn. Two seconds later, the green light keeps "ON" means it is ready.

2. When the helicopter is finished signal connection and is not under shooting condition, the

indicator light of the videography module keeps constant "ON". At this time,

Turn the switch button on videography module to the direction of the videography icon (Pic. 1),

and then turn on the camera switch of the remote control, it will start taking videography and

the red light of module keeps flashing. Press the camera button again, videography taking

will be stopped.

Turn the switch button on videography module to the direction of the photography icon (Pic. 2),

and then press the camera button on the remote control to take photos.

3. After shooting is finished, take out the TF memory card from the videography module

and insert it into the card reader, then, insert the card reader into the USB interface of

the computer to watch the video.

To stop shooting, please press the shooting switch on the remote controller. Directly

unplug the battery cable or take out the TF memory card from the videography module

will result in loss of the video data.

To avoid helicopter crash,please do not insert or take out the TF memory card from the

videography module,when the circuit is on. TF memory card should be installed before

circuit is on and take out after shooting switch is turned off.

When crash occurs,turn off the helicopter and then turn on the power to recover normal

working.

When the red light and the green light of the vediographic device keep flashing

alternately, it means that the TF memory card is not inserted or the TF memory card is

damaged. It is possible to restore the memory card by reformatting(Take out the TF

memory card, then, insert it into the car reader, then, connect it to the computer and

format the memory card)

The red light will keep constant "ON" to indicate insufficient memory.

Pic.1

TIPS

Pic.2