Ametek Gemco 952CP Ram-Set Manual de instalación y mantenimiento - Página 18

Navegue en línea o descargue pdf Manual de instalación y mantenimiento para Controlador Ametek Gemco 952CP Ram-Set. Ametek Gemco 952CP Ram-Set 20 páginas. Automatic press shut height controller

Imprimir página

Note: Malfunctions due to the above can usually be cleared by removing, and then reconnecting power to the control-

ler. The cause of such problems can be determined and eliminated. If removal and reconnection of power does not

correct the problem, a controller failure has occurred. If the outputs are operating properly, the failure is most likely in

the display section. If outputs do not operate properly, the failure is most likely in the CPU section.

Chapter 5: Programming and Function Charts

Password

Function

Number

Program new die #'s and positions

753

Clear all die #'s and positions

System offset

Transducer calibration (wire speed)

Up/down counting direction

Slow-down entry point

Upper limit

Lower limit

Time-on for slow dwell

Time-off for slow dwell

Trouble fl ags

Review all programmed dies & positions

Ram "In Position" window

Software number

Inches/mm

100

Remove a specifi c die # and position

200

Counter balance override

268

Diagnostics (Function #268)

391

Initialization

555

Jogging with system errors (Function #555)

Note: If an attempt is made to enter too large a value, the display will show EEEEE4. If this value is too small, the

display will show EEEEE3. Example: Entering a ram position outside of the upper and lower limits.

Initialization

Description

Installation and Maintenance Manual

Chapter 4: Maintenance and Trouble Shooting

Value

N/A

48 In. Max. Pos.

9.040 in/sec.

0 (Up)

0.050 inch

48.999 inch

0.000 inch

0.40 sec.

N/A

.010 inch

N/A

N/A N/A

Range

Up to 5 digits

N/A

0 to 99.999 inch

1.000 to 65.000 in/sec.

0=Up; 1=Down

0 to .259 inch

0 to 48.999 inch

0 to 24.999 inch

0 to 9.99 second

N/A

0- to .099 inch

N/A

0 or 1

N/A

0 to 15

N/A