Coinco Money Controls MC7200 Manual de instalación - Página 4
Navegue en línea o descargue pdf Manual de instalación para Contadoras y clasificadoras de monedas Coinco Money Controls MC7200. Coinco Money Controls MC7200 20 páginas. Bill acceptors
Imprimir páginaNOTE: The Metal mounting plate must be connected to earth
ground.
1. Remove power from host machine.
2. Set bill acceptor dip switches, if required. (see Page 5).
3. Install the bill acceptor into the host machine using the mounting
studs and hardware in the machine.
4. Install / Connect the proper interface harness to the host machine.
5. Apply power to the machine, verify that the Green Flashing Arrows on
the front of the bill acceptor (with standard mask) are ON and blink-
ing. This condition indicates that the bill acceptor is ready to accept
bills.
• If the Lights are off, check connections and make sure power is
applied.
• Also check the rear diagnostic LED, the status codes are listed on
the cashbox and in the figure below.
6. Check Operation, once the Green Arrows are flashing, insert bills to
verify proper acceptance and credit.
# of LED Flashes
Normal Pulse Rate
1 pulse per second
Fast Pulse Rate
3 pulses per second
Not Lit
Steady ON
2 Flashes
3 Flashes
4 Flashes
5 Flashes
Installation
Diagnostic LED
Ready
Check Stacker/Cashbox
Check Power
Replace Acceptor
Bill Inhibited
Disabled by Host
Clear Bill Path
Clean Bill path
Page 4
LED Status