ASTRO TOOL Corp. MS3191-1 Manual

Navegue en línea o descargue pdf Manual para Herramienta eléctrica ASTRO TOOL Corp. MS3191-1. ASTRO TOOL Corp. MS3191-1 2 páginas. Connector assembly tooling, hand crimping tool and related types

Imprimir página

GENERAL

The Astro Tool 10692 MS style Crimp Tool is a cycle

controlled, precision Crimp Tool capable of crimping wire

barrel sizes 12 to 20. The Tool is shipped with 3 Positioners

for size 20, 16 and 12 contacts. Store positioners in the Sheet

Metal Handle under the Spring Loaded Plug.

There are no adjustments for the operator to perform. The

Tool's precision cycle-control mechanism eliminates over or

under crimping. Color coded positioners locate contacts in

proper position and automatically sets the proper crimp depth

and proper ratchet release.

A positioner must be installed to operate the Tool.

BASIC TOOL OPERATION

The Tool must be in the fully open position. Exert full

pressure on the handles to trip ratchet, then release.

The handles will spring to the full open position.

Loosen the Slide Locking Screw. Pull the Slide to the

open position. See figure # 1

Pull Trigger Assembly back against spring pressure.

ASTRO TOOL CORP.

CONNECTOR ASSEMBLY TOOLING

10692 (MS3191-1) HAND CRIMPING TOOL

AND RELATED TYPES

Slide Lock Screw

Trigger Assembly

Slide

Flat in Tool

Figure # 1

Spring Loaded Plug

Select the proper Positioner for contact to be crimped

and insert into Tool as shown, see figure #2. Ensure

that the flat on the Positioner Flange mates with the

flat in the Tool. The Flange on the Positioner must be

flush with the Handle before the Slide can be fully

closed.

Flat

After the Positioner is in place, release the Trigger.

Move the Slide back into position and tighten the

Locking Screw.

Insert the prepared contact and wire through the

Indenter Body and into the Positioner. Squeeze the

Handles until the Tool comes to a positive stop.

Release the Handles and the Tool will return to the full

open position.

Remove the crimped assembly.

Do not press down on wire during the crimp cycle.

Positioner

Figure #2

CAUTION:

10-27-97 TI692-93-3