Flying Thingz FT3007 Manual de construcción - Página 5

Navegue en línea o descargue pdf Manual de construcción para Juguete Flying Thingz FT3007. Flying Thingz FT3007 8 páginas.

Imprimir página

Tape another set of 12" skins

together for the top and bottom of

the outer panel. Lay both of the

panels on the balsa and cut the

skin in half for each side.

10.

Use the same procedure as

the inner panel to sheet the outer

panel. Make sure to leave the extra

balsa at the TE. Note that there is

washout in the outer panel and

care should be taken not to untwist

this during the sheeting process.

11.

Use the core beds to align

and apply the top sheeting. This

will maintain the correct wing twist.

Trim away the extra balsa and

sand the sheeting flush with the

cores.

12.

Cut 2 sections of sheeting for

the middle wing cores. Tape them

together as before. Use the same

procedure to glue the sheeting to

the cores.

13.

Sand the excess balsa down

to the cores. Again, make sure not

to change the angles of the wing tip

and root joints.

14.

Now join the outer wing to the

middle wing. This is a 0 deg joint

so simply lay the sections on your

building board and epoxy together.

Align the LE's and the TE should

be flat on the table. Make sure to

coat both joints good. Use 5 Min

epoxy and tape in place until cured.

15.

Flip the wing over so the

dihedral angle is rising up off your

building table. Tape the wing

section securely to the table with

the TE flat along it's length.

16.

Use the foam angle brace to

prop up the inner wing to the outer

section. Check the joint and make

sure you have a good flat mating

surface. Lightly sand to correct any

difference. The Wing is upside

down in this picture.... Remember

we are building a gull wing, so

double check the angle before you

glue. Use 5 min epoxy and tape

securely till cured.

Page 5