ASTRO-PHYSICS GTOCP4 Manual - Página 12

Navegue en línea o descargue pdf Manual para Controlador ASTRO-PHYSICS GTOCP4. ASTRO-PHYSICS GTOCP4 13 páginas. First session with control box

Getting Started

Configure your WiFi from the GTOCP4's built in web pages. If you can open the web page from a

browser using an Ethernet connection, please do so. It's probably the fastest and easiest.

If you will be configuring from a wireless device, start by joining the GTOCP4's wireless Access Point

network.

1. In your wireless device (laptop, smartphone, tablet, etc.) open the device's wireless settings page.

2. Find the network for the GTOCP4 in your device's list. It will be named: GTOCP4_Net_XXXX as

described earlier, where the XXXX at the end represents the numeric portion of the CP4's serial

number without leading zeros.

3. Connect your device to the network. You will be prompted for a password. The default password

starting out will be: XXXXadmin12345 where again, the XXXX represents the numeric portion of

the serial number without leading zeros. For the GTOCP4 with serial number CP4-0092, the

password would be: 92admin12345

4. Once your device shows that it is connected to the GTOCP4's Access Point network, open the

devices browser.

5. In the browser's URL address bar, enter the following IP address: 172.31.0.1 and then the

equivalent of "Enter"

This will bring up the GTOCP4 Main Web page just like the Ethernet version. From this page, you can

move on to the Change Network Connection or Advanced WiFi pages. On these pages, you can

choose the default WiFi connection, and you can change the Access point Network Name if you

wish. It is highly recommended that you change the password to something more secure since

anyone with access to this manual and knowledge of your serial number can determine the

factory default password. The new password will NOT take effect until the GTOCP4 is power-

cycled.

Important Note: Most devices are smart enough to ask you for the new password when you try

to connect after you have made a password change. This is, unfortunately not the case with

Windows 7 and some later versions as well. Once a Windows computer has made a

connection with your original password, it may simply fail to connect instead of asking you for

the new password. It won't even have the courtesy to tell you why it failed to connect.

To remedy this in Win 7, click on the little WiFi symbol at the far right of the task bar. This will

open a small box with the listing of all the currently available WiFi Networks. Find the

GTOCP4's WiFi name and right-click on it. Select "Properties". In the next little window that

opens, go to the Security Tab. Here, you can enter your new password where it says "Network

Security Key. To make it easier, check the box to show the characters - just remember to un-

check it when you are finished. Once the password is entered, click OK. Now you should be

able to connect using Windows.

In Win 10, You will want to access the Network & Internet section of the new Settings App. This

can be done by either opening the app or by clicking the same WiFi icon mentioned above for

Win 7, and then clicking the settings link at the bottom of the list. First, try connecting to the

GTOCP4 from the settings page. It will hopefully then present you with a request for additional

information (this means the password). If it does not, then click Manage WiFi Settings at the

bottom, select the GTOCP4 from the list and tell Windows to forget it. Now power-cycle the

GTOCP4, allowing at least a minute or so between power-off and power-on. (Windows needs