FlyingFoam Nurf Instrucciones generales de montaje - Página 2

Navegue en línea o descargue pdf Instrucciones generales de montaje para Aviones FlyingFoam Nurf. FlyingFoam Nurf 11 páginas.

 .188 carbon fiber tail pin

 3" wide fiberglass tape

 (2) Bamboo Skewers



Recommended Tools/Supplies:

 Hobby knife with #11 blades

 Snap-blade knife

 Sanding block with medium grit (120-150) paper

 5 minute epoxy

 CA – Medium and Thick

 Fiber-reinforced packing tape

 Masking tape

 Covering iron

 Rotary tool with small router bits

 Flat building surface

 1/2" brass tube

Assembly Instructions

NOTE: We strongly recommend building the wing first as this will allow you to test fit

the wing on the uncompleted fuselage in order to place your gear for best CG position.

Wing Core Preparation 

1. Start by separating the wing cores from the beds. SAVE THE BEDS - They will be used

throughout

Note: It is normal for the beds to stick to the cores, so be careful when separating.

2. Lightly sand the cores to remove imperfections. A sanding block with 120 grit

sandpaper works well for this.

3. Use a knife to remove any flashing or excess EPP from the beds. It is important the

cores lay flat in the beds, as it will help ensure building a straight wing.

4. Vacuum or use compressed air to remove all dust and remaining debris.

Join The Wing Cores

5. Tape the bottom beds together with a strip of masking tape. Repeat for the top beds.

6. Glue the wing halves to the center wing section with 5-minute epoxy. Align the wing

in the bottom beds and use tape to hold the joints. Apply weights to hold flat, or hold

with your hands if you are not doing anything for the next 5 minutes. When the epoxy

sets, remove the weights and masking tape.

Rev 2.0 10/21/13