AIR GUARD AG-800 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Máquina de niebla AIR GUARD AG-800. AIR GUARD AG-800 8 páginas.

During these 15 seconds, the user can set the controller. When the setting is completed, the green

light will stop blinking and then turn into a green light. If the user wants to use a controller to control

two or more machines at the same time, he can start all the machines he wants to control, and then

press the controller A key to complete the setting within 15 seconds after starting.

Please note that when there is a new controller to be linked with the machine, no matter how many

sets of previously completed controllers will be washed out, you need to re-link.

Machine Notes

1. All sterilizers will have liquid condensation at the nozzle, which will cause the accumulator to

accumulate on the surface below the nozzle, so please consider this situation when setting up the

machine。

2. All sterilizers emit a small amount of smoke every few minutes during standby. Even after a short

period of time after the machine is turned off, the machine will emit a small amount of smoke.

3. After spraying smoke, all the sterilizers will temporarily stop themselves to prepare for repeated

heating. During this period of reheating, the machine was unable to emit smoke.

4. The AG-800 is equipped with an electronic flow detector. When the remaining oil is insufficient,

the pump will stop automatically and the LED on the back will flash to indicate that the oil is

insufficient. At this time, please add disinfectant to the oil drum. This will remove the warning

light.

After adding disinfectant, the machine can resume normal use。

Clean and store

1. Do not allow the disinfection solution to be contaminated by impurities, and immediately cap the

bottle after each addition.。

2. The cabinet can be wiped with a damp cloth。

3. Before storing the machine, pour distilled water into the oil drum and run the machine to clean

the heating system to avoid blockage of the pump and electric heating pipe.

4. It is recommended to allow the machine to warm up and run at least once a month to keep the

machine at its best performance and output conditions.

5. Excessive dust and liquid residue on the machine will reduce the performance of the machine and

cause poor heat dissipation.

*** Regular cleaning of the machine helps reduce expensive parts replacement and repair costs.。

M22 Moisture Co., Ltd.

Tel.+886 3 3225829 – Fax +886 3 3220433

www.airguard.com.tw