Astroflex VKE-103 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Arranque a distancia Astroflex VKE-103. Astroflex VKE-103 8 páginas. Astroflex electronics remote keyless entry owner's guide

Imprimir página

off. After the ignition has been turned off, the status LED flashes slowly to indicate that the AED

will be activated then, the LED flashes normally when AED has been activated.

NLOCKING

Pressing

for one second unlocks the doors (if connected). The horn will honk twice (if

connected) and the parking lights will flash twice to confirm reception of the command. The

optional Failsafe

Starter Kill will be deactivated. The status LED will turn off.

Note: If the doors were locked with the remote transmitter, you

must use the transmitter or the Valet switch to deactivate the starter

kill. Manually unlocking the vehicle will only unlock the doors.

ISABLING THE

If your remote transmitter is lost or damaged, you can manually override the AED. To do this, you

must have the vehicle's ignition key and know where the Valet

with the installer for the location of the Valet

If the vehicle does not start, you may have waited too long;

Location of Valet Button____________________________________________________

ILENT MODE

To temporarily turn OFF the horn honk(s) confirmations, simply press

before transmitting any commands, the confirmation honk(s) will not be present for that one

operation only.

ALET MODE

You can prevent your system from automatically activating the Failsafe

included) by using Valet

In Valet

Mode, the starter kill cannot be activated, even with the transmitter, but all convenience

functions (door locks, trunk release, etc.) will continue to work normally.

Note: For AED to be effective, the Failsafe

Starter Kill relay must be installed.

AED

WITHOUT A TRANSMITTER

To disable the AED, turn the ignition to the ON position.

Press and release the Valet switch within 10 seconds. The

status LED will stop flashing and the vehicle should start.

turn the ignition off and repeat the process.

Mode. This is very useful when washing the vehicle or having it serviced.

switch is located. Be sure to check

switch.

for less than one second

Starter Kill (optional, not