COLE CL1350 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Plotter COLE CL1350. COLE CL1350 16 páginas. Cutting plotter

Cole Plotter User Manual

parallel cable and setting up the Artcut software to plot through the

LTP1 port. If you do have problems you can try the following steps.

1.Verify all cables are connected properly and try rebooting the

computer and/or plotter.

2.Make sure you have a parallel cable not longer than 12' (the shorter the

better).

3.No other devices or switchboxes should be connected or daisy

chained to the parallel port.

4.Try changing your parallel port mode to ECP if it is not already. This is

done in your computer setup (BIOS) and is it recommended that only

advanced users adjust this setting.

5.Remove any other devices that are listed in control panel>Faxes

and printers. You will not actually see the plotter installed as a device

here but since it uses a driver through the cutting software but any

other installed parallel drivers could interfere with the plotter.

Serial

For Serial simply connects the serial cable to the PC and set the

Artcut software to print through COM1, and if that does not work try

COM2.

Built-in USB

Please refer to "USB dirver Installation under Windows XP.pdf". Once

the drivers are installed, you will need to go into device manager and

change the USB port from COM4 (or default setting) to COM1 or COM2

so that it can be recognized in Artcut 2005. As mentioned before the

USB connection is the same speed as a serial port. This is the most

difficult connectivity method since it is the only method where it is

necessary to install a driver. The driver is for the USB conversion cable

and not the plotter itself.

1.Before connecting the plotter install the driver from the mini driver disk

http://www.cncoletech.cn/