Air Hogs Zero Gravity Laser Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Coche de juguete motorizado Air Hogs Zero Gravity Laser. Air Hogs Zero Gravity Laser 4 páginas.

PROBLEM
Vehicle will not run.
Vehicle does not climb walls.
Vehicle does not drive well.
Vehicle slips climbing walls.
Vehicle falls off the wall.
NOTE: If normal function of the product is disturbed or interrupted, strong electro-magnetic interference may be causing the issue. To reset product, turn it
completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again.
To ensure normal performance, change the batteries, as low batteries may not allow full function.
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B
digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. Because this toy
generates, uses, and can radiate radio frequency energy, there can be no guarantee that interference will not occur. If this toy does cause interference to radio or television reception
(you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna
• Increase the separation between the toy and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc.) could result in a violation of
FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.
This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
IMPORTANT SAFETY INFORMATION: Keep clear from face, eyes, and hair at all times. Do not aim at people or animals. Use caution; make sure people around you know that you are
playing with AIR HOGS
. Stay away from obstacles and electrical hazards. Play with this product in a wide-open room, far away from breakable items. Avoid playing near vents and/or fans,
®
as these may over power this product and make it difficult to control. NOTE: Always get permission to play with this product indoors. Please retain this information for future reference. Use
alkaline batteries for best performance. ADULT SUPERVISION RECOMMENDED.
BATTERY SAFETY INFORMATION:
• Requires 6 x 1.5V AA batteries (not included)
• Batteries are small objects.
• Replacement of batteries must be done by adults.
• Follow the polarity (+/-) diagram in the battery compartment.
• Promptly remove dead batteries from the toy.
• Dispose of used batteries properly.
• Remove batteries for prolonged storage
• DO NOT incinerate used batteries.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• DO NOT mix old and new batteries or types of batteries
(i.e. alkaline/standard).
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• DO NOT short-circuit the supply terminals.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,
Williamsville, NY 14221, USA
Spin Master Toys Far East Limited. Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
The Zero Gravity
Laser™ Wall Climber has
a working LED light on the
top of the car.
1. Power switch is off. Turn on.
2. Controller battery is installed with incorrect polarity. Check (+) and (-) markings to make sure the battery is properly aligned.
3. Batteries are drained. Install new batteries.
1. Turn vehicle off for 30 seconds then restart.
2. Suction is jammed. Remove debris by blowing gently on the fan area located on the bottom of the vehicle.
1. Make sure surface is clean of dirt/dust. 2. Make sure surface is neither too rough or too smooth.
3. Make sure surface is flat.
1. Clean the tires with a damp rag. 2. Fold up the fabric skirts for a better seal prior to use.
1. Make sure to discharge and then charge again for 30 to 50 minutes.
2. Clean tires and make sure your wall and floor are also clean.
3. Check the fabric skirts for damage. If they have been pulled loose, tape them back on with flexible tape.
4. Make sure surface is flat.
Your Zero Gravity Laser™ is equipped with a
Lithium Polymer battery.
!
WARNING:
• Never charge battery unattended.
• Charge battery in isolated area. Keep away from
flammable materials.
• Do not expose to direct sunlight.
• There is a risk of the batteries exploding,
overheating, or igniting. Do not disassemble,
modify heat, or short circuit the batteries. Do not
place them in fires or leave them in hot places.
• Do not drop or subject to strong impacts.
• Do not allow the batteries to get wet.
• Only charge the batteries with the specified
Spin Master™ battery charger.
®, TM and © 2009 Spin Master Ltd. Air Hogs ® is a registered trademark of Spin Master Ltd. All rights
reserved. Conforms to product safety standards ASTM F963, regulatory requirements. • Please retain
this information for future reference. • Please remove all packaging materials before giving to children.
• An adult should periodically check this toy to ensure no damage or hazards are found, if so, remove
from use. • Children should be supervised during play. • Keep addresses and phone numbers for
future reference. • The item inside this package may vary from the photographs and/or illustrations.
Patent Pending. MADE IN CHINA.
20029107, 20029109
T44366_0007_20029107_NBL_IS_R1
IMPORTANT: When the LED begins to blink, the battery is
running low on power. Car should be removed from the wall
immediately. Other wise the vehicle may fall off the wall.
TROUBLESHOOTING
SOLUTION
NBL English
REV 0
4
• Only use the batteries in the device specified by
Spin Master™.
• Carefully read the instruction guide, and use the
batteries correctly.
• In the unlikely event of leakage or explosion use sand
or a chemical fire extinguisher for the battery.
• Batteries must be recycled or disposed of properly.
WARNING:
!
Do not point the LED light at eyes. It is rare but
possible for seizures to be triggered by light
flashes. To reduce exposure to such potential,
do not flash lights directly into eyes.
TM