Dorex DX2 FW Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Sistema de apertura de puertas Dorex DX2 FW. Dorex DX2 FW 16 páginas.

Imprimir página

05. LOCATE TEMPLATES AND PREPARE DOOR

Top Latch

and Strike

Template

C L

Center

Case

Template

C L

Bottom Latch

and Strike

Template

07. CENTER CASE INSTALLATION

1. Verify if exit device rail length needs be shortened. If yes, refer to

step 9. The exit device requires a minimum clearance of 1-3/16"

between the frame's door stop and the rail end (with end cover

removed). Otherwise install the exit device on door as required

with a trim or without a trim.

2. If exit device is used with a trim, attach the exit device and the

appropriate trim using instructions and hardware supplied with the

trim and the exit device.

3. If no trim is used and the exit device is surface mounted on the

door, used supplied mounting hardware as indicated on pages 2,

3, and 4.

4. Fire exit devices must be installed with through-bolts when

installed without a trim.

1-3/16"

Center Case

Screws

7/16"

1. CAUTION: Prior to using supplied

templates, verify that the templates are

printed to full scale, by measuring some of

the indicated dimensions.

2. Position the center case template in line

with the marked horizontal and vertical

centerlines as shown. Tape the template on

the door and mark the cut-out and mounting

holes centers on the door's interior side.

3. If trim is used, prepare the door exterior

side using the template and installation

instructions for that trim.

4. With door closed, fold the appropriate top

latch and strike template on the door stop

and inside door surface as shown, ensuring

the vertical centerline aligns with the exit

device vertical centerline. Tape template on

the door and frame, then mark the mounting

hole centers.

5. Fold the appropriate bottom latch and strike

template on the door bottom surface and

floor as shown, ensuring the vertical

centerline aligns with the exit device vertical

centerline. Tape template on the door and

floor and mark the mounting hole centers.

6. Drill and tap required holes and cut the

required cut-outs as indicated on page 4 of

the door preparation document.

7. Attach approprate center chassis strike as

per steps 2 and 3.

8. Attach approprate top strike as per step 6.

Optional

Trim

If a 5/8" diameter hole

is required for the

electrified exit device,

the hole must be

positioned as shown

06. INSTALL TOP STRIKE AND SHIM

08. INSTALL BOTTOM LATCH

1. Following the marking of the bottom strike in step 5, prepare the floor for the appropriate

strike and mounting screws

2. If strike is installed on a threshold, provide the required holes and attach strike with

supplied screws.

3. Bottom strike can be installed after bottom latch installation to ensure a proper alignment.

Pullman Latch

(Defaut)

Round Bottom Latch

6 / 16

Shim

DXAS106

Strike Screws

DXAS215

Shim

DXAS108

Default for DX2FW

Strike Screws

Install a screw through each slot.

DXAS227

(Default)

DXAS225

Shim

DXAS203

Default for DX2PW

Strike Screws

DXAS224

DXAS226