Asus AT3IONT-I Series Manual del usuario - Página 23
Navegue en línea o descargue pdf Manual del usuario para Placa base Asus AT3IONT-I Series. Asus AT3IONT-I Series 48 páginas. Asus computer hardware
También para Asus AT3IONT-I Series: (French) Guía De Inicio Rápido (28 páginas)
Imprimir página
6.
System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
AT3IONT-I SERIES System panel connector
•
System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the chassis power LED
cable to this connector. The system power LED lights up when you turn on the system
power, and blinks when the system is in sleep mode.
•
Hard disk drive activity LED (2-pin HD_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable
to this connector. The HD LED lights up or flashes when data is read from or written to
the HDD.
•
ATX power button/soft-off button (2-pin PWRBTN)
This 2-pin connector is for the system power button.
•
Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot without
turning off the system power.
7.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
AT3IONT-I SERIES Chassis intrusion connector
ASUS AT3IONT-I Series
F_PANEL
Reset
GND
Ground
PWR
IDE_LED-
PLED-
IDE_LED+
PLED+
CHASSIS
GND
Chassis Signal
+5VSB_MB
1-14