Asus B150-PLUS Manual técnico - Página 3

Navegue en línea o descargue pdf Manual técnico para Placa base Asus B150-PLUS. Asus B150-PLUS 18 páginas. Pin definition

Clear RTC RAM (2-pin CLRTC)

This header allows you to clear the Real Time Clock (RTC) RAM in

CMOS. You can clear the CMOS memory of date, time, and system setup

parameters by erasing the CMOS RTC RAM data. The onboard button

cell battery powers the RAM data in CMOS, which include system setup

information such as system passwords.

To erase the RTC RAM:

Turn OFF the computer and unplug the power cord.

Use a metal object such as a screwdriver to short the two pins.

Plug the power cord and turn ON the computer.

Hold down the <Del> key during the boot process and enter BIOS setup to re-

enter data.

•

If the steps above do not help, remove the onboard battery and short the two pins

again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the

battery.

•

You do not need to clear the RTC when the system hangs due to overclocking. For

system failure due to overclocking, use the CPU Parameter Recall (C.P.R.) feature.

Shut down and reboot the system, then the BIOS automatically resets parameter

settings to default values.

RTC Battery header (2-pin BATT_CON)

This connector is for the lithium CMOS battery.

Chassis intrusion header (4-1 pin CHASSIS)

This header is for a chassis-mounted intrusion detection sensor or

switch. Connect one end of the chassis intrusion sensor or switch cable

to this connector. The chassis intrusion sensor or switch sends a high-

level signal to this connector when a chassis component is removed or

replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled "Chassis Signal" and "Ground" are shorted

with a jumper cap. Remove the jumper caps only when you intend to use

the chassis intrusion detection feature.

Motherboard Pin Definition

CLRTC

PIN 1

BATT_CON

VBAT

GND

PIN 1

CHASSIS

1-3