bolid S2000-SP1 ORION ISS Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Teclado bolid S2000-SP1 ORION ISS. bolid S2000-SP1 ORION ISS 10 páginas. Executive relay module
También para bolid S2000-SP1 ORION ISS: Manual de instalación (8 páginas)

Imprimir página

1.2.3 The current consumed by the module (without regard to connected executive

devices):

300 mA max at 12 V (all relays are switched on);

–

20 mA max at 12 V (all relays are switched off);

–

150 mA max at 24 V (all relays are switched on);

–

15 mA max at 24 V (all relays are switched off).

–

1.2.4 The number of executive relays with switching contacts is four.

1.2.4.1 The maximum switching current of each relay (continuous load) is:

− 7(10

− 7(10*) A for a resistive load at 30 V dc;

− 4 A for an inductive load (cosϕ = 0.4) at 250 V ac;

− 4 A for an inductive load at 30 V dc.

1.2.4.2 The maximum switching power of each relay is:

− 300 W max for dc;

− 2500 VA max for ac.

1.2.4.3 The maximum switching voltage of each relay is:

− 280 V at 8 A ac;

− 125 V at 0.5 A dc.

1.2.4.4 The minimum switching load for each output is 6 V at 0.1 A

1.2.5 The overall dimensions of the module are 157 mm x 107 mm x 36 mm.

1.2.6 The weight of the module doesn't exceed 0.35 kg.

1.2.7

The pre-operation time of the module since its powering on is 5 s max.

1.3 Standard Delivery

1) S2000-SP1 mod.01 Executive Relay Module

2) Instruction Manual

3) Installation Manual

4) Woodscrews

5) Wall Plugs

6) DIN 7982 Flat Head Tapping Screw 2.2х6,5

7) Fuse 10 A

8) Package

1.4 Performance

1.4.1 Operating algorithms of the module's relays are defined in the configuration of the

network controller (either S2000 console or PC under ORION Pro software), which controls

the relays by means of commands being sent to the S2000-SP1 mod.01 relay module over

the RS-485 interface bus.

1.4.2 The module provides executing the following commands received over the RS-485

interface:

Reading the configuration parameters stored in the module's non-volatile memory;

–

Writing the configuration parameters stored in the module's non-volatile memory;

–

Assigning a network address to the module;

–

∗

10 A for a short time load (no more than for a minute with the pauses between switching on of min 20

minutes)

∗

) A for a resistive load (cosϕ = 1) at 250 V ac;

– 1 pc.

– 3 pcs.

– 1 pc.

– 2 pcs.

– 1 pc.