Dorlen Water Alert SS-1 Instrucciones

Navegue en línea o descargue pdf Instrucciones para Sensores de seguridad Dorlen Water Alert SS-1. Dorlen Water Alert SS-1 2 páginas.

Imprimir página

Water Alert detector provides local and remote alarms

when activated.

- Used in applications requiring a single detector and remote

alarm. Often used in noisy or unattended areas.

PRINCIPLE OF OPERATION

Refer to Figure 1. The SS-1 is activated by liquid bridging the adjustable sensors (A & A). The unit can detect

water film from zero height, (sensors turned out to make contact with the floor), to 1/8" height, (sensors turned

all the way in). The units are factory adjusted to activate with 1/32" water film height which is satisfactory for

most applications. The pads B1, B2, B3 provide a gap between the case and the surface to admit water under

the unit for detection. CAUTION: If the pads are removed, the unit may form a seal with the surface and prohibit

the sensors from detecting water. If desired, the self-adhesive pad feature may be used by peeling off the thin

protective layer from each pad. The unit will remain in place when located on the mounting surface. Replace-

ment pads are available from Dorlen at no charge.

Although the two sensors (A & A) may be adjusted to make contact with the surface, it is recommended

that a small gap be set between the sensors and the surface so undesired activation, caused by damp-

ness or dirt film, does not occur.

If you have installation questions, call toll free 1-800-533-6392

Instructions for Model

(Model

XSS-1

50' of wire (furnished)

SILENCE

ALERT

ACTIVATED

Remote alarm enclosure

SS-1

when using optional Sensor Cable)

FLOOR

WHEN WATER FILM FORMS

A BRIDGE BETWEEN SEN-

SORS (A&A), WATER ALERT

IS ACTIVATED.

Figure 1

NOTE:

Water Alert

Powering options -

- 9v Alkaline Battery (Qty.2)

- PS-3 Power Supply (Pg. 25- catalog)

- Voltage Module (Pg. 26- catalog)

Audible alarm -

- 85db @ 3 feet

- 1.5 day alarm duration

(Battery Operation)

Remote alarm -

- 85db @3 feet w/ silence switch

- 9/16" Red lamp

- Wall Mounted 6"x3"x2" enclosure

- 50' Cable included

Power draw -

- 40ma @ 9vdc (activated)

Warranty -

- 5 Year Limited, Made in USA

FLOOR