Canon REALIS WUX10 MARK II D Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Proyector Canon REALIS WUX10 MARK II D. Canon REALIS WUX10 MARK II D 24 páginas. Projector
También para Canon REALIS WUX10 MARK II D: Manual del producto (12 páginas), Manual del producto (13 páginas), Folleto y especificaciones (12 páginas), Folleto y especificaciones (4 páginas), Manual del producto (18 páginas), Características (19 páginas), Manual del usuario (1 páginas), Folleto (27 páginas), Preguntas frecuentes (1 páginas), Especificación del producto (2 páginas), Folleto (32 páginas), Folleto y especificaciones (12 páginas), Folleto y especificaciones (12 páginas)

CCCCTCC C

C1C

Introduction Crocess

Prepare for introduction of this software as shown below.

C Creparing an administrative

2 Creparing the Crojector

3 Installing the Software

4 Configuring Network

Settings of the Software

Introduction

computer

▼

Prepare an administrative computer that is

connected to a network. Projectors connected to

the local area network can be managed.

If the network is managed under a subnet,

network settings on the administrative computer

must be configured to gain access to the target

projector. Contact the system administrator for

details.

Connect a projector for management to the

network, and configure its network settings. In

addition, you must configure the SNMP settings

of the projector when using SNMP protocol. For

procedures on configuring the projector, see the

instruction manual that came with the projector.

Install this software on to the administrative

computer.

(see p. 4, 1.3 Installing the Software)

Configure the protocol settings and the polling

interval settings for discovery.

(see p. 5, 1.4 Configuring the Network Settings

of the Software)

CHAPTER 1 • Introduction