Dorma ES 90 Manual - Página 7

Navegue en línea o descargue pdf Manual para Abrepuertas de garaje Dorma ES 90. Dorma ES 90 14 páginas.

Imprimir página

4.2

Activators

Test all connected

switch settings.

the activators

in accordance

installation

instructions.

4.3

Emergency opening -

operation with back-up battery module

Set the program switch to "OFF" and remove

mains plug.

Lock should not disengage and door should not

open.

Set program switch to "AUTOMATIC".

Door should unlock and open.

Re-insert mains plug.

Door should close at creep speed.

Leave program switch in "AUTOMATIC"

and remove mains plug.

Door should open.

4.4

Emergency stop-

operation with backup battery module

Set program switch to "AUTOMATIC"

during the closing cycle. operate the

emergency stop switch.

Door should stop and reverse.

4.5

Lock

Set program SWitch to "OFF".

• Door should be locked in closed condition.

In all other program switch settings.

• Door should be unlocked.

The lock can be adapted with the hand terminal

request of the customer.

(See hand terminal

4.6

Night-bank

Set program switch to "OFF".

Issue an opening signal uSing the

"NIGHT

- BANK" activator.

The door should unlock and open.

The door should close and lock automatically

the user has passed through the door or, at the

latest, on expiry of the pre. set

"NIGHT

- BANK hold.open

Remove mains plug

Issue an opening SIgnal using the

"NIGHT.

Door should unlock and open as long as the

NIGHT.

BANK - signal remains live.

With the KT 8 key switch as the activator,

door can also be unlocked

disconnected.

Push the door closed by hand.

Turn the key switch counter-clockwise.

Door should lock.

E_S90_/lOO__

activators

in the various program

Perform settings and adjustments

with the corresponding

and

operating

instructions)

activator

t,me",

BANK" activator.

if the power is

~~J

5. Further information

The door system performs a self-test

for

at appropriate

times after the system has been

switched on.

In this self-test,

performed under battery power and the control unit is

checked for integrity.

door remains in the open position.

The door can be closed by setting the

program switch to "OFF".

At the next opening signal, a further

performed.

6. Optional functions

If the functions

setting

implemented,

they must be tested as follows.

6.1

Air lock (two doors in tandem)

Depending on the side from which the opening signal

is initiated.

the first door in the access sequence

should initially

Only after the first door has closed should the second

door open and close.

6.2

Presence detector (bell contact)

Check the bell contact by interrupting

barriers.

6.3

Door status monitor

Check the audible or visual door status detectors.

6.4

Panic/emergency

It'

at the

The panic/emergency

ill

to special statutory

is imperative

relevant national regulations.

The panic/emergency

using the DIP switches and hand terminal.

Initiate

a NIGHT/BANK

switch modes "AUTOMATIC",

OPEN" and "PERMANENT

once

• The door should close immediately.

The door should not open either when the light barriers

are interrupted

detectors.

Cancelling

the panic/emergency

Set the program switch to

required mode.

Then test all the other functions.

the

Opening and reversing via the radar detector.

• Reversing via the light barriers.

every 4 hours or

an emergency opening cycle is

If the self-test

should fail, the

self-test

described

below have been

open and then close.

the light

closing

closing function

is subject

regulations.

Consequently,

to ensure compliance

with the

closing function

must be set

signal in each of the program

"EXIT ONLY", "PARTIAL

OPEN".

or when a signal is issued

radar

closing function:

uOFF",

and then back to the

t-Jt-1

DORMA