dormak CR43 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Cortacésped dormak CR43. dormak CR43 12 páginas.
Imprimir página
15. Never lift or carry the machine when the
engine is running or if it is connected to the
power supply.
16. Disconnect the equipment from the
power supply:
- Everytime the machine is left unattended
by who has the hability to operate it;
- Before removing any object that may be
blocking the machiner;
- Before checking or handling any electric
component;
- If the machine hits an object. Do not re-use
the equipment without making sure that it is
in good working and safety conditions;
- If the machine starts vibrating in an unusual
way, switch it off immediately and check if
the blade is correctly tightened. In doubt,
refer to an Dormak's authorized agent.
2.7. Storage and maintenance
1. Danger : do not touch a blade when it is
rotating, only when it is stopped, with no
connection to the power supply and wearing
protective gloves and adequate clothing.
2. Keep every screws, pins and nuts well
tightened, to asure that the machine is
working under the best safety conditions.
3. Check frequently the grass bag looking for
any kind of wear or damage.
4. For safety and performance reasons
08
replace all the dammage or worn parts.
5. All the replacement parts to be applied on
this machine must be Dormak origin, or have
Dormak's approval.
6. Store the equipment on a cool dry location,
out of reach of children. Do not store on the
outside.
03.
laWn-MoWer
asseMbling
3.1. Guiding handlebar assembling
1. Remove the protective sponge which
covers the handlebar;
2. Make sure that the electric cable isn't
wraped and position it on the outside of the
handlebar;
3. Insert the handlebar on the lower arm as
shown in picture A;
4. Select the required handlebar height, 1 or
2, and insert the screws (picture B);
5. Position the rapid clamping screw axle into
its hole (picture C), clamp it (X turns) and lock it.
6. Place the cable fixing braces as shown on
picture D.
3.2. grass bag assembling
1. Hook the suport wire of the grass bag on
the hard-top, as shown in picture E.