Cansec Canlan M200 Manual de inicio rápido - Página 6

Navegue en línea o descargue pdf Manual de inicio rápido para Controlador Cansec Canlan M200. Cansec Canlan M200 6 páginas.

Configure

1. Address Configuration - enter the IP address, subnet mask, default gateway, and

port number provided by your network administrator.

2. Operational Mode - select your access control system.

NOTE: Idle auto-disconnect is enabled by default for SmartLock Pro/SMA, Zodiac Max

and SmartLock Pro Plus with a value of 1.

3. Remote Diagnostics - select remote diagnostics and enter an optional 8-digit

password.

4. RS485 Serial Interface – These settings are set accordingly when the operational

mode is selected. Maestro and SmartLock Pro/Connect share the same default

settings. Zodiac Max also shares the same settings except the baud rate is set to

38400. The default settings for Maestro and SmartLock Pro/Connect are as

follow:

Baud Rate: 9600

Parity: None, 1 Stop Bit

Data Bits: 8 Bits

5. IP Security is optional. Select the checkbox "Only allow connections from the IP

below" and enter the IP address that is allowed to connect to this Canlan for

communication. Leave the checkbox unchecked if IP Security is not used.

6. Click Save if any changes were made.

7. Optionally, click Backup to back up the configuration to a binary file for future

restoration. The file will be saved in the same folder as the Canlan configuration

software.

CanLan M200

Quick Start Guide

Page 6 of 6

April 2014 • Rev. 1.3