Cansec P-620-HA Manual de instrucciones de instalación - Página 14
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lector de tarjetas Cansec P-620-HA. Cansec P-620-HA 14 páginas. Canprox proximity/keypad reader
Imprimir página
- 1. Table of Contents
- 2. Specifications
- 3. Introduction
- 4. Wall Mounting
- 5. Wiring - Cansec Controllers
- 6. Wiring - 3 Rd Party Controllers
- 7. Programming
- 7. P-640-HA & P-620-HA (26-Bit Wiegand Output)
- 7. P-640-HA37 & P-620-HA37 (Cansec 37-Bit Wiegand Output)
- 8. Proximity/Keypad Reader Usage
- 9. Card + PIN Interface Module - Optional
- 9. Card + PIN Usage
- 10. Reader/Keypad Troubleshooting
- 11. Appendix
Appendix
8-BIT BURST KEYPAD MODE
While in the 8-bit burst mode each key press results in the reader transmitting 8 bits of
data to the host.
The Proximity/Keypad Reader is usually shipped in 8-bit burst mode. However, if it was
programmed to output standard 26-bit Wiegand or Cansec 37-bit Wiegand then follow
the steps below to enable 8-bit burst:
1. Cycle power to the reader.
2. Present the Wiegand Keypad Data Mode control card to the reader – reader will
beep four times.
3. Press the "#" key – reader will beep four times to indicate success.
4. Press "*" key – reader should beep once to indicate 8-bit burst is enabled.
CanProx Proximity/Keypad Reader is compliant with the following organizations:
CanProx Proximity/Keypad Reader
Installation Instructions
Page 14 of 14
August 2018 • Rev. 1.6