cantaport KCR Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Refugios cantaport KCR. cantaport KCR 6 páginas.

step one

. .

cantaport

2900mm

Centred to posts

2900mm

inside to outside

Set out for the cantaport KCR 5130, KCR 5120 ,KH 5127.Please read

the easy 6 step cantaport installation in conjunction with the manufacturers

installation manual and the engineers certification.

The cantaport posts to be set at 2900mm centred between the posts.

Height to be determined from the finish ground level. Standard height set

at 2310mm from the finished ground level.

. .

cantaport

FGL

Pine timber beams can be used

to support the posts near the top

and bottom of each posts. Timber

blocks can be nailed onto the beams

at the required distance to keep the

posts level and in position.

The bottom rail can be packed or

supported off the finished ground

level.(FGL)

Clamps can be fixed between the

timber beams and the posts to

provide more stability. Further bracing

can be fixed to the top beam to restrict

any movement during the concrete pour. Allow minimum 200mm of concrete around each post. Refer to the

engineerʼs certification for more details with regards to the concrete footing dimensions, soil conditions and wind rating

allowances.

Place metal rod anchor through the holes at the base of the posts. Check that the posts are level from the front and

the side. The height of one post can be lowered slightly to allow for water to fall inside the gutter to one side.

Take care during the installation of the posts. To avoid any scratches always place cardboard or rubber between the

surface of the posts and any timber bracing . The posts can be set 100mm either side from the standard set out.

New holes will need to be drilled for the bearers over the beams to accommodate the fixing points.

step two

Timber beam

Clamp