Dormakaba LA GARD 5715 Instrucciones de uso - Página 2
Navegue en línea o descargue pdf Instrucciones de uso para Sistema de interfono Dormakaba LA GARD 5715. Dormakaba LA GARD 5715 2 páginas. Electronic entry device
También para Dormakaba LA GARD 5715: Instrucciones de uso (2 páginas)
Imprimir página
2. Press the "0" key
3. Enter your NEW combination two times (plus eKEY, if enabled). You must insert and remove eKEY each
time, if enabled.
4. If a mistake is made, wait thirty (30) seconds and repeat steps 1-3.
5. Test lock operation using new combination (+ eKEY) several times before closing the door."
• Valid Combination Entry - Double signal after valid combination is entered.
• Invalid Combination Entry - Triple signal indicates the old combination is still valid.
KEYPAD BACKLIGHT
• Press either lightbulb icon.
• Panel keys will remain backlighted for approximately 8 seconds.
• The backlight feature will not adversely affect battery life if done in conjunction with normal anticipated
keypad usage.
BATTERY LOW WARNING
• Repeated LED flashing and beeping during an opening indicates that the battery is low and needs
immediate replacement.
• Uses one (1) 9-Volt alkaline battery. (Example: Duracell™ or Eveready™ alkaline batteries.) It is
recommended that batteries be replaced at least once a year.
If battery is depleted and will not allow lock to open, follow instructions below. Lock contains a
non-volatile memory. Even with batteries removed, the lock will retain all programming.
CHANGING YOUR BATTERY
1. Open the battery door (black plastic compartment cover located at the bottom of the keypad) by gently pulling the tab down and to the right.
2. Allow the battery and its attached leads to drop down and out of the battery compartment. If it does not drop, gently pull on the battery until
it drops out.
3. Remove the connector by unsnapping it from the two terminals on the top of the battery.
CAUTION! Hold on to battery terminal connector to avoid pulling the wires out of the housing.
4. Press and hold the zero (0) key for ten (10) seconds before installing a battery.
5. Connect a new 9-Volt Alkaline battery to the battery clip.
6. Gently push the battery and the leads completely into the battery compartment.
7. Close the battery door by rotating it up and to the left, gently pressing the latch side into place.
NOTE: The audit features, the software features, features associated with peripheral devices and systems, optional interconnect devices and
their associated features, features involving the use of user keys, the duress feature, monitoring features, remote features, and other additional
features have not been evaluated by UL. Models 8130 and 3190 keypads are not certified by UL, are not UL listed, and not approved for UL
applications."
Mounting Instructions available at www.kaba-mas.com.
(P/N) 7032.0316 Rev A 02/17 • © copyright 2017
© 2017 Kaba Mas LLC • All rights reserved.
749 W. Short Street, Lexington, KY 40508 USA
Phone: (859) 253-4744 FAX: (859) 255-2655
Technical Support: (800) 950-4744
www.kaba-mas.com
Kaba Mas LLC
Page 2 of 2