Dorman 99135 Instrucciones

Navegue en línea o descargue pdf Instrucciones para Mando a distancia Dorman 99135. Dorman 99135 3 páginas. Keyless entry remote

Imprimir página

INSTRUCTIONS

KEYLESS ENTRY

REMOTE

99135

BEFORE YOU BEGIN:

• Always wear proper safety

equipment when performing repairs.

• Ensure at your point of purchase

that this part fits your exact

vehicle configuration.

• Reference the appropriate service

manual for your vehicle. If you do

not have a service manual, and do

not have the training or experience

to perform the necessary

procedures correctly, seek the

services of a qualified technician.

NEED HELP?

Please call our Technical Support

team for assistance from our team of

certified automotive experts.

1-866-933-2911

99135_Instructions

NOTE: All currently programmed and new remotes must be reprogrammed

to vehicle. Please have all remotes in hand at time of programming.

INSTRUCTIONS

STEP 1:

Insert key into ignition and turn to key on, engine off.

NOTE: Programming can be affected by voltage fluctuation. Ensure battery

voltage of 12.6VDC is maintained throughout this entire procedure.

STEP 2:

Insert programmer into the vehicle' s OBD-II port. This port is typically located

underneath the dashboard below the steering wheel.

STEP 3:

Once the programmer is inserted, wait for the programmer to chime followed by

a red flashing light on the programmer. This will indicate that the unit is ready to

program the first remote.

STEP 4:

While the light is flashing, press and hold the lock and unlock buttons on the

remote simultaneously for five seconds, then release and immediately press and

hold the unlock button until the programmer or vehicle responds with a chime

(approximately one second), buzzer, or the door locks lock and unlock, followed by a

one time flash of green. Release the unlock button.

STEP 5:

To program additional remotes, wait for the light to begin flashing red again and

repeat Step 4. All remotes (new and existing) must be reprogrammed during this

sequence.

STEP 6:

Remove programmer when all remotes have been programmed (up to four total).

Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.

Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-

tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to

do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage

or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor

Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such

standards and that you do not disable any motor vehicle safety feature.

PAGE 1 OF 3