Asus TUF GAMING B450M-PRO S Manual - Página 11

Navegue en línea o descargue pdf Manual para Placa base Asus TUF GAMING B450M-PRO S. Asus TUF GAMING B450M-PRO S 29 páginas.
También para Asus TUF GAMING B450M-PRO S: Manual de instrucciones (32 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas)

Imprimir página

ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are

designed to fit these connectors in only one orientation. Find the proper orientation

and push down firmly until the connectors completely fit.

•

CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN1/2)

Connect the fan cables to the fan connectors on the motherboard, ensuring that the

black wire of each cable matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside

the system may damage the motherboard components. These are not jumpers! Do not

place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan

of maximum 1A (12 W) fan power.

AMD AM4 CPU socket

The motherboard comes with an AMD AM4 socket designed for AMD Ryzen™

2nd Generation/ Ryzen™ with Radeon™ Vega Graphics/ Athlon™ with Radeon™

Vega Graphics/ Ryzen™ 1st Generation processors.

For more details, refer to Central Processing Unit (CPU).

Aura RGB Strip headers (4-pin RGB_HEADER1/2)

These headers are for RGB LED strips.

The RGB headers support 5050 RGB

multi‑color LED strips (12V/G/R/B), with a

maximum power rating of 3A (12V), and no

longer than 3m.

Before you install or remove any

component, ensure that the ATX power

supply is switched off or the power cord is detached from the power supply. Failure to do

so may cause severe damage to the motherboard, peripherals, or components.

1-2

We recommend that you use an ATX 12V Specification 2.0‑compliant power

supply unit (PSU) with a minimum of 350W power rating. This PSU type has 24‑pin

and 8-pin power plugs.

DO NOT forget to connect the 8‑pin EATX +12V power plug. Otherwise, the

system will not boot up.

We recommend that you use a PSU with higher power output when configuring a

system with more power‑consuming devices or when you intend to install additional

devices. The system may become unstable or may not boot up if the power is

inadequate.

RGB_HEADER

PIN 1

+12V G R B

1 2 V

Chapter 1: Product introduction