dafi IPX5 Instrucciones de montaje y uso - Página 2
Navegue en línea o descargue pdf Instrucciones de montaje y uso para Calentador de agua dafi IPX5. dafi IPX5 12 páginas. Electric a flow heater with an open outlet water
También para dafi IPX5: Manual de instrucciones (13 páginas)
Imprimir página
Prior to installation, carefully read the
This equipment can be used by children at least 8 years of
age and persons with reduced physical, mental, and people with
lack of experience and knowledge, if it will be ensured
supervision or instruction concerning use of the equipment in
a safe manner that risks are understood. Children should not
play with the equipment. Children should not be allowed to
perform the cleaning and maintenance of equipment.
1. General information
Water heaters with bare heating elements DAFI are heaters in which
the heating water takes as it passes through the heating block heater,
where the bare (not isolated) heating elements (twisted heating, made of
wire resistance) are washed by flowing water and work only during the
download of hot water (supply voltage twisted heating is switched link
flow when the flow of water through the heating block). Thanks to a very
low thermal inertia of the heating element hot water flows out of the
heater immediately after opening the hot water tap.
Flow water heaters with bare heating elements DAFI heaters are
a very high energy efficiency of approximately 98% and energy efficiency
E<0.125 kWh/K). To heat 1 liter of water at 40-45°C DAFI heaters
consume only approx. 0,033 kWh of electricity. For comparison, eg. the
energy efficiency of storage water heaters with a capacity of 30 l approx.
80% and a capacity of over 30 liters approx. 83%.
Heater DAFI has a hygienic certificate PZH certificate of conformity
"CE" certificate entitling to mark the product safety mark "B", "CB Test
Certificate" issued by the Polish Centre for Testing and Certification SA in
Warsaw.
Heater DAFI has a protective certificate issued by the Patent Office
No. 53535/95.
2. Characteristics heater DAFI
DAFI heater is intended to heat the water supply. It is mounted at
the outlets of water, washbasins, kitchen sinks, showers, etc. It can be
installed to one or more of the domestic hot water. The heater is
particularly useful buildings and facilities not equipped with gas
installation. We recommend the installation DAFI heaters at each water
intake in order to avoid loss of water and electricity. Thanks to the very
low thermal inertia of the heating element heated water is replaced
immediately after opening the hot water valve.
DAFI heaters produkowne are the following power: 700W 3; 4 500W;
5 500W; 7 230V 300W and 7 500W; 9 000W; 11 000W 400V voltage.
Electrical power is only when the water flow, so that its consumption is
lower than in reservoir water heaters. The heating power determines the
quantity and temperature of heated water. By adjusting the intensity of
the stream of water flowing through the heater may lower or raise the
temperature of the water.
instructions!