Dot Origin VTAP100 Manual de instalación - Página 15
Navegue en línea o descargue pdf Manual de instalación para Unidad de control Dot Origin VTAP100. Dot Origin VTAP100 17 páginas. Desktop usb reader
También para Dot Origin VTAP100: Manual de instalación (13 páginas), Manual de instalación (16 páginas)
Imprimir página4.4 Antennas
The VTAP100 OEM module has been tested with its integrated loop antenna, printed on the
PCB. There are no alternative antennas approved for use. If an external antenna is attached,
the new arrangement would require a new FCC approval.
4.5 Label and compliance information
The integrator must attach a label to the new equipment, hosting the VTAP100 OEM module,
which states 'Contains FCC ID: 2A282-VTAP100'.
4.6 Information on test modes
The following test modes are recommended to achieve states of maximum emission levels or
susceptibility in the VTAP100 OEM module:
1. VTAP100 OEM module powered on. Communicating with PC over USB. Continuously
reading tag.
2. VTAP100 OEM module powered on and tag present, but not communicating with external
device.
4.7 Additional testing requirements
The VTAP100 OEM module is only FCC authorised for use in compliance with the specific
FCC transmitter rules listed on the grant. The integrator is responsible for compliance to any
other FCC rules that apply to the host, which are not covered by the modular transmitter
grant of certification.
The final host product, with the VTAP100 OEM module installed, will still require Part 15
Subpart B compliance testing, to evaluate transmission effects when the VTAP100
OEM module and host equipment operate at the same time. Be aware that additional
testing can be required on the final integrated system. We recommend integrators refer to
further advice from the FCC OET Knowledge Base, such as 996369 D04 Module
Integration Guide v02.
VTAP100 OEM MODULE
INSTALLATION GUIDE
© DOT ORIGIN
VTAP MOBILE WALLET READERS
PAGE 10