Dot-Spot brilliance Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Iluminación paisajística Dot-Spot brilliance. Dot-Spot brilliance 15 páginas.

Imprimir página

Assembly

Free cabling

Attention:

The cable of the brilliance RGB features a wire which is not used (brown or gray). Nor-

mally, the wire is shortened ex works and should not be connected.

Connection diagram of the brilliance RGB

See respective drawing in the middle of this manual (p. 15).

brilliance RGBW

Wire color

white

red

green

blue

brown

black

Connection diagram of the brilliance RGBW

See respective drawing in the middle of this manual (p. 15).

M12 plug and cabling system

The connection of the brilliance versions with M12 connector is quite simple, either with or without

dimming function. Plug the connector of the luminaire in a free socket of the M12 cabling system.

The M12 cabling system is coded in a way to avoid wrong wiring or failures.

Please plan the components required for the electrical installation (power supplies, distributors,

extensions and plugs for unassigned M12 sockets) according to the sales documentation of the

M12 cabling system before placing an order.

Assignment of the M12 connector system

Pin number

Wire color (if plug

M12 plug

is pinched off)

brown

white

blue

black

green/yellow (gray)

Assignment

+ 12 V

red S-PWM

green S-PWM

blue S-PWM

white S-PWM

ground (-)

5-pin plug

brilliance white / monochro-

brilliance RGB

matic

24 V +

red S-PWM

24 V +

green S-PWM

S-PWM

12 V +

ground

blue S-PWM

ground

Operation

LED lights are extremely energy efficient and, under normal operation, have a very long life. To

ensure the maximum life of the LED and to increase the energy efficiency, the following should be

considered:

■ The turning on and off of the luminary should be carried out by the input circuit of the power

supply.

■ The turning off of the luminary via the PWM signal should not occur permanently since in this

case the electronics unit of the luminary continues operating.

■ Even if the luminary is equipped with a THERMOPROTECT system that protects the luminary

against thermal damage, a permanent abnormal operation should be avoided.

■ The heat dissipation of the LED must not be hindered. Therefore, do not cover the spot.

■ Avoid operating the spot in case of direct solar radiation.

■ In automatic mode, control the spot via timer and / or twilight switch.

Maintenance, disposal

Care

■ Clean the spot with a damp cloth every now and then.

■ The luminaries are made of stainless 316 L steel. However, depending on the environmental

conditions and the surfacing material, the metal parts may present the so-called flash rust, but

this does not constitute a defect. Flash rust can be removed easily with appropriate stainless

steel cleaners. Flash rust is particularly likely when the housing comes into contact with ferrous

particles (e.g. iron and grinding dust, ferrous plant fertilizers or the like).

Illuminants

LED lights, under normal operation, have a very long life. Therefore, the replacement of the lamp is

not provided. In case of questions, see the Service chapter.

Disposal

At the end of the useful life, dispose of the spot and all accessories in accordance with the appli-

cable environmental regulations. Electrical waste must not be disposed of with domestic waste.