DAGU RS025 Manual - Página 7

Navegue en línea o descargue pdf Manual para Robótica DAGU RS025. DAGU RS025 12 páginas.

Wiring Instructions:

Once you have assembled the robot you need to connect the wires. Start by checking that the jumper near the

power switch is selecting 5V for power. If it is set to battery voltage then the sensor outputs might be high

enough to damage the digital inputs D2 & D3.

Connect the left and right motors as shown in the photo. Make sure the jumpers are on D7, D8, D9 & D10 so

that the processor is connected to the motor driver. Now connect the power wires from the battery. Make sure

you connect the red wire to the +positive connection.

Next we need to connect the servo and wheel encoder sensors. These all have three wires - black/brown is

the ground wire and goes to the outer edge of the PCB. The red wire is the +positive and should be in the

center. The white/orange wire is the signal wire and will be closest to the processor.

The right wheel sensor connects to D2, the left wheel sensor connects to D3 and the servo is connected to

D12.

Battery +

Battery -

Power

Switch

+V: Bat/5V

D11

D12

D13

Gnd 5V

D9 D7 D10 D8

motor

USB

5V G

G T

Gnd

ATmega

Left

Right

motor

Reset

D13

LED