Double Horse 9116 Manual técnico - Página 3

Navegue en línea o descargue pdf Manual técnico para Juguete Double Horse 9116. Double Horse 9116 8 páginas.

Imprimir página

DH9116 Transmitter - Original Factory Program Menu Settings.

Terms used within the transmitter and this blog.

TX = Transmitter

ELEV = Elevator (cyclic movement forward or backward)

AILE = Aileron (cyclic movement side to side, slide left & right)

RUDD = Rudder (to increase or decrease tail rotor thrust, spin the tail left or right)

THRO = Throttle (increase or decrease motor rpm, to raise or lower the helicopter in altitude)

D/R = Dual Rate (increase or decrease servo maximum throw)

EPA = End Point Adjustment (increase or decrease to match the servo arm movements with transmitter control

stick travel)

Note: All stick trims are to be centered, throttle stick is at its lowest position; rocker switch is in the 'quick"

position.

Switch the TX on; the battery voltage indicator shows full and the actual voltage value flashes and fluctuates;

the red LED flashes and the buzzer beeps 14 times quickly, then changes to a higher pitch single beep, then

falls silent; the red LED also stops flashing (this is the end of the transmitter bind or helicopter to transmitter

signal synchronization mode).

Long press of the MENU button; after 1 second the backlight glows;

MODE Flashes; 2 is visible (to change modes, press up or down, press menu to save and exit)

Press of the MENU button and ELEV SUB F flashes - 000 ("F" suddenly appears next to the RUDD TRI)

press of the SEL button, AILE SUB L flashes - 000

press of the SEL button, THRO SUB F flashes - 000

press of the SEL button, RUDD SUB L flashes – 000

press of the SEL button, back to ELEV SUB F flashes – 000

press of the MENU button, ELEV D/R - 100%

press of the SEL button, AILE D/R flashes - 100%

press of the SEL button, RUDD D/R flashes - 100%

press of the SEL button, back to ELEV D/R flashes - 100%

press of the MENU button, ELEV REV flashes – REV

press of the SEL button, AILE REV flashes - REV

press of the SEL button, THRO REV flashes - NOA

press of the SEL button, RUDD REV flashes – REV

press of the SEL button, back to ELEV REV flashes – REV

press of the MENU button, ELEV EPA flashes - 100% (RUDD TRI changes to F)

To change the F to B, move the elevator stick forward or backward to change.

press of the SEL button, AILE EPA - 100% (RUDD TRI changes to R)

To change R to L, move the aileron stick side to side.

press of the SEL button, RUDD EPA - 100% (RUDD still at R)

To change the R to L, move the rudder stick side to side.

press of the SEL button, back to ELEV EPA flashes - 100% (RUDD TRI changes back to F)

press of the MENU button, THRO TRI 0 - 000%

press of the SEL button, THRO TRI 1 - 025%

press of the SEL button, THRO TRI 2 - 050%

press of the SEL button, THRO TRI 3 - 075%

press of the SEL button, THRO TRI 4 - 100%

press of the SEL button, back to THRO TRI 0 - 000%

press of the MENU button, back to mode - 2

END OF MENU