Dahle 846 Instrucciones de instalación de las cuchillas - Página 2
Navegue en línea o descargue pdf Instrucciones de instalación de las cuchillas para Cortadoras de papel Dahle 846. Dahle 846 2 páginas. Ream cutter
También para Dahle 846: Manual de instrucciones (14 páginas)
Imprimir página
Blade Removal Instructions for the DAHLE 842, 846, and 848 Ream Cutter
Tools You Will Need
•
3 mm hex key
•
4 mm Hex Key*
•
5 mm Hex Key*
•
Blade Carrying Device*
*Included in blade replacement kit
1.
With a 3 mm hex key,
remove the hex screws on
the clear plastic cover to
the left of the cutting blade
(while facing the machine).
Remove the cover.
3.
Remove the four hex
screw on the top of the
clear plastic safety cover
located to the right of the
cutting blade (while facing
the machine).
Remove
the cover.
2. Lift the cutting arm to its
highest position. With a 4
mm hex key, remove the
two screw on the left side
of the blue metal blade
cover.
Once the screws
are removed, lift the cover
and slide it over the top of
the handle.
4.
Lower the cutting arm to its
lowest position.
Locate the
blade and the three hex screws
that hold the blade in place.
Remove the center hex screw
and insert the blade carrying
device (looks like a screwdriver
with threads on the tip) and
tighten. Remove the remaining
two hex screws that hold the
blade in place.
6.
Once the blade is free,
remove it from the cutter
and place it in a safe
container.
5. Lift the blade arm to its highest
position.
Loosen
the
carrying device a few turns. With
b o t h
h an d s ,
gen t ly
downward being careful to keep
fingers clear of the blade. If the
blade does not move, loosen the
blade carrying device a little more,
lower the cutting arm, and again
gently push the blade downward.
blade
p u s h