Electralog CS2307 Manual práctico del usuario - Página 7

Navegue en línea o descargue pdf Manual práctico del usuario para Estufa Electralog CS2307. Electralog CS2307 10 páginas. Compact stoves
También para Electralog CS2307: Manual del usuario (13 páginas)

Imprimir página

RESETTING THE TEMPERATURE CUTOFF SWITCH

Should the heater overheat, an automatic cut out will turn the heater off and it will not come

back on without being reset. It can be reset by switching the MAIN ON/OFF SWITCH to OFF

and waiting 5 minutes before switching the unit back on.

CAUTION

If you need to continuously reset the heater, unplug the unit and call customer service at

1-800-668-6663.

MAINTENANCE

WARNING

Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire,

electric shock or damage to persons.

Compact Stove SURFACE CLEANING

The clear door is cleaned in the factory during the assembly operation. During shipment,

installation, handling, etc., the clear door may collect dust particles, these can be removed by

dusting lightly with a clean dry cloth.

To remove fingerprints or other marks, the clear door can be cleaned with a damp cloth. The

clear door should be completely dried with a lint free cloth to prevent water spots. To prevent

scratching, do not use abrasive cleaners or spray liquids on the clear door surface.

Compact Stove SURFACE CLEANING

Use warm water only to clean painted surfaces of the Sub-Compact Stove. Do not use

abrasive cleaners.

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity

and detail of the log exterior disappears. There are two bulbs under the log set which generate

the flames and embers.

LOWER LIGHT BULB REQUIREMENTS

Quantity of 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 25 watt

rating.

TO REPLACE THE LIGHT BULBS

1. Remove the five screws from the access panel, located on the back of the unit, and

Remove access panel.

2. Locate and examine the bulbs to determine if replacement is required.

3. Unscrew the bulbs counter clockwise.

4. Insert new bulbs.

5. Secure access panel to unit.