Colzer AF500 Manual - Página 3

Navegue en línea o descargue pdf Manual para Limpiador de aire Colzer AF500. Colzer AF500 7 páginas. Hepa air scrubber

OPERATION

1) Place the Air Scrubber upright on a level and stable surface with the handle up.

2) Remove the dust cover.

3) Plug the Air Scrubber into a grounded 115 volt grounded outlet with the correct voltage and amperage.

For maximum protection against electrical shock, ALWAYS use a circuit that is protected by a ground

fault circuit interrupter. If you are unsure about the outlet, check with a qualified electrician or service

person. Do not use an adapter or extension cord.

4) To switch the unit on, locate the control panel and turn the variable speed switch clockwise to the

desired speed setting. Check that the Air Scrubber operates properly before leaving it unattended.

5) Operate unit until area is clear of unwanted contaminates or until filters need to be changed. The

control panel has a filter change light which illuminates when the HEPA filter needs to be changed. See

section on changing filters for instructions.

AUXILIARY/GFCI OUTLET/DAISY-CHAIN

You can interconnect ("daisy-chain") up to three AF500 s to customize your air filtration needs. The GFCI

will "trip" if it detects a sudden "ground fault," or overload and interrupt the electric current. When the

GFCI "trips," unplug the unit and look for potential hazards such as standing water, frayed cords, or

anything that would cause a dangerous electrical problem. If such a situation exists, plug the AF500 into

a different outlet and then push the "reset" button which is located between the 2 outlets on the GFCI. If

the unit will not operate check the circuit breaker section below.

The AF500 is equipped with a circuit breaker switch to protect the Air Scrubber. The switch is located

directly above the GFCI outlet and cuts off power to the unit when it detects an unsafe amount of

electricity passing through the unit. If the switch "trips," unplug the unit and look for potential hazards or

anything that may be creating an overload situation. "Reset" breaker by pushing button in and continue

normal operation.

HOURCOUNTER SETUP

The AF500 is equipped hour counter button to shut off the machine automatically after 1/2/4/8 Hours.

To set the function, you need to turn on the machince, then press the Hour Counter button on the control

panel. ( "1h" is machine will shut off in hour, "2h" is 2 hours, "4h" is 4 hours, "8h" is 8 hours)

AIR QUALITY LIGHT

The AF500 is equipped with air quality light to show the air quality of the enviroment.

RED means the air is polluted, need to use AF500 to clean the air asap.

YELLOW means the air quality is not good, keep the AF500 on.

GREEN means the air quality is good, AF500 can be turned off.