Colzer PD223A Manual del usuario - Página 18

Navegue en línea o descargue pdf Manual del usuario para Deshumidificador Colzer PD223A. Colzer PD223A 20 páginas.

『TROUBLE SHOOTING』

Error Code

Problem

Humidity Sensor Malfunction

Defrost Temperature Sensor

Malfunction

Ambient Temperature Sensor

Malfunction

Water bucket is full.

The water bucket has not been

installed properly.

Float Malfunction

Note:

When E1, E2, or E4 error displays, you can hear an alarm that could last 15 seconds. In this case, the

dehumidifier is still running. You can follow the below steps to eliminate the error message:

· Pressing any button on the control panel to eliminate the alarm.

· Turn off the dehumidifier and unplug it to check if any obstructions.

· Restart the dehumidifier 10 minutes later..

If the ERROR message does not disappear after the restart, immediately contact COLZER customer

Please try the below steps to reset the dehumidifier if necessary:

1) Turn the dehumidifier off;

2) Press and hold the LIGHTING button for 5 seconds, until dF flashes on the LCD screen;

3) Press the MODE button once;

4) Wait for 5 seconds to let the system auto-reset to default settings.

3. Trouble Shooting

The below chart will help you solve common problems that may occur. If the problem you come

across can not be fixed after troubleshooting or the problem is not listed in the below

troubleshooting chart, please contact COLZER customer service to obtain professional support at

Solution

1. Check the humidity sensor and ensure it is

in good condition.

2. Replace the humidity sensor.

1. Check the temperature sensor and ensure

it is in good condition.

2. Replace the temperature sensor.

1. Check the temperature sensor and ensure

it is in good condition.

2. Replace the humidity sensor.

Empty the water bucket.

Re-install the water bucket properly.

Replace the float of the water bucket.