Baumer OADM 20I6591 Manual del usuario - Página 38

Navegue en línea o descargue pdf Manual del usuario para Accesorios Baumer OADM 20I6591. Baumer OADM 20I6591 48 páginas. Laser distance sensor

5.2 How to reset the factory settings using the teach button

Within 5 minutes after power up, the button may be used to reset the sensor back to the factory settings.

After finishing a teach

procedure,

the 5 minutes starts again. After the 5 minutes, the sensor does not

respond to the button.

1. Push the button. The red LED will turn on, if the sensor can be taught.

2. Hold down the button further 5 sec. The LED will start to blink. DO NOT RELEASE the button now. Wait

another 10 sec until the LED is ON without blinking. Factory settings have been restored to the sensor.

3. Release the button.

Until button has been

t12

released (t13)

Red LED

5.3 How to teach a new range using the external teach input

Teaching the sensor via the external teach input is equivalent to the teaching procedure via the button. There

is no 5 min. time limit. The sensor may be taught at any time. In addition to the LED, the alarm output is used

to indicate the state of the sensor for an external digital controller.

12-28 V

Teach wire

0 V

☺

Red LED

☺

Alarm

t10

Manual_OADM20x659_DE_EN.doc

38/48

Baumer

04.12.12

Frauenfeld, Switzerland