Baumer GBPAH Manual - Página 10

Navegue en línea o descargue pdf Manual para Media Converter Baumer GBPAH. Baumer GBPAH 10 páginas. Absolute encoders with biss c interface

7 Register communication

Writing of the registers calls for utmost care and attention. Writing only of the registers listed in

this document. Incorrect register writing may cause the encoder outputting incorrect values.

Writing only of the command register (0x60).

Do not write in any other register.

Soft preset (0x60 = 0x02)

Writing 0x02 in register 0x60 will execute preset. (zero set as default).

Any other preset value requires the corresponding default parameter predefined at Baumer.

The error register

Bit "0" is the only one to signal error ERR_L (infrared LED current limit error) in the BiSS C frame.

The warning bit is not used.

Transmission current error:

ERR_L

0x68; bit 0

Code

Function

no control error present

amplitude exceeded, or outside control range*

Figure 6

* EFL580 – outside temperature limit

Error bit transmission is usually inverted (low active).

Error Reset

The error reset is automatically executed at position data reading.

BiSS encoders are programmable to allow for customer-specific parameterization. Should you

require another different from default, you may approach your Baumer contact for support to

ensure proper encoder functionality by the correct configuration. We gladly will be of help.

Baumer_BiSS-C_MA_EN_V1 00.docx

25.08.2016

10/10