Douglas Dynamics 77705 Manual de instrucciones de instalación - Página 8

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Accesorios para automóviles Douglas Dynamics 77705. Douglas Dynamics 77705 14 páginas. Light truck snowplow

Imprimir página

HEADLAMPS

WARNING

Your vehicle must be equipped with snowplow

headlamps and directional lights.

Headlamps, hardware, and instructions are found in

the headlamp box.

1. Install the vehicle wiring according to the

instructions provided.

2. Set the headlamp channel on the headgear, label

to the front, with the holes aligned.

3. With the correct headlamp on the correct side, set

each headlamp and swivel into place as shown.

4. Secure the headlamps with the correct hardware

for the application as shown. Inner and outer posts

require different hardware. On LED headlamps, a

rubber washer must be installed under the slotted

holes. Hand tighten.

5. Connect the headlamp wires to the headlamps.

6. Aim the headlamps according to the Snowplow

Headlamp Beam Aiming Instructions (Lit. No.

27769). For LED headlamps, tighten the fasteners

to 22 ft-lb (30 N·m). For halogen headlamps,

tighten the fasteners to 50 ft‑lb (68 N·m).

Halogen Headlamps

Lit. No. 52524, Rev. 05

INSTALLATION INSTRUCTIONS

Headlamp

Swivel

Headlamp

Channel

Lift Frame

1/2" Flat

Washers

1/2" Lock

Washers

1/2" Hex Nuts

From inside the headlamp channel, insert the

cable tie anchors into the holes as shown. The

anchor locking tabs should be horizontal.

Grommet

Cable

Ties

8. For halogen headlamps only, install a split rubber

grommet on each headlamp wire 3" from the

headlamp. Insert the grommet and wire into the

slot on the rear of the channel.

9. Route the wires under the channel and down the

back of the driver‑side vertical support. Secure the

wires to the anchors and the vertical support with

cable ties.

LED Headlamps

Cable Tie

Anchors

Run harness

underneath

channel.

Slotted

Hole

1/2" Rubber

Washer

July 15, 2020