Baumer PMG10P Manual de instrucciones - Página 24

Navegue en línea o descargue pdf Manual de instrucciones para Media Converter Baumer PMG10P. Baumer PMG10P 40 páginas. Absolute encoder
También para Baumer PMG10P: Instrucciones de montaje y funcionamiento (32 páginas), Instrucciones de montaje y funcionamiento (36 páginas), Instrucciones de montaje y funcionamiento (32 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (40 páginas), Manual de instrucciones (40 páginas), Manual de instrucciones (36 páginas)

Imprimir página

Electrical installation

6.2.6

Output switching behavior Speed switch (optional)

INFO

Default switching speed is 6000 rpm for HMG10P and PMG10P. HMG10 and PMG10 without

programming interface come with the individually ordered permanent switching speed.

Event

During initialization

After initialization and speed being ≤ -ns (off)

-ns (off) < speed ≤ -ns (on)

-ns (on) < speed ≤ +ns (on)

+ns (on) ≤ speed < +ns (off)

+ns (off) ≤ speed

High resistance

Resistance between

SP+ and SP-

Low resistance

+ns (off) = Switch-off speed at shaft rotation in positive rotating direction*

-ns (off) = Switch-off speed at shaft rotation in negative rotating direction*

Switching hysteresis

+ns (on) = Switch-on speed at shaft rotation in positive rotating direction*

-ns (on) = Switch-on speed at shaft rotation in negative rotating direction*

6.2.7

Connecting the supply cable

NOTICE

Equipment damage due to dust or moisture

Inappropriate cable diameters may entail ingress of dust or moisture. In this case, the protection

class is no longer ensured causing device failure or malfunction.

a) Use only appropriately sized cables to make sure the specified protection class is being en-

sured.

INFO

Connection cables are not included in delivery.

Tools

t20

-n

-ns (off)

= Speed

: 10...100 % (factory setting = 10 % min. 1 Digit)

22 mm

Operating Manual

Speed switching output state

High-impedance (overspeed)

Status unchanged

Device rotation within this speed range during

initialization results in status low-impedance

(no overspeed) after initialization

Low impedance (No overspeed)

Status unchanged

Device rotation within this speed range during

initialization results in status low-impedance

(no overspeed) after initialization

High-impedance (overspeed)

-ns (on)

+ns (on)

Baumer Hübner

+ns (off)

PMG10 & PMG10P EtherNet/IP | V1