Comanche BITS Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas Comanche BITS. Comanche BITS 6 páginas. Bungee installation tool system

2. Remove the bungee access inspection panel behind

and slightly outboard of the main landing gear wheel

well. The landing gear bungee arm, pulley, and the

inboard portion of the bungee are now in plain view.

3. Either with an assistant in the cockpit or by reaching

through the storm window raise the landing gear

slightly by putting the gear switch in the up position

and intermittently bumping the master switch. Raise

the gear just enough so that the bungee arm is lined up

with the bungee cord and bringing it to its full

extension.

4. Remove the detent ring pin on the bungee installer

tool and collapse the tool to its shortest length. Insert

the outboard end of the tool between the bungee cord

halves and push it toward the outboard pulley. The

saddle flanges will guide it toward the outboard

pulley.

5. Turn the inboard end of the tool sideways to get the

top flange to engage the top bungee half and then

rotate the lower flange in to engage the lower cord.

The tool should now be suspended between the

bungee halves.

6. Push the two parts of the installer tool apart until the

detent ring pin holes line up so you can re-insert the

detent ring pin. It may be helpful to use a number 2

Phillips screwdriver or suitably sized drift to

accomplish this.

7. Raise the landing gear the rest of the way to the full up

position.