amphead VASP Blackbuck TDA7265 Instrucciones

Navegue en línea o descargue pdf Instrucciones para Amplificador amphead VASP Blackbuck TDA7265. amphead VASP Blackbuck TDA7265 2 páginas.

Imprimir página

sr.

Description

Unpolarized capacitor

Polarized capacitor

Resistor 1/4 watt

Resistor 1/2 watt

Zener diode

TDA7265 / TDA7292 / TDA7269

Wire Jumper

Speaker Out Left Channel

Speaker Out Right Channel

Subwoofer Out

Positive Supply

Ground Connect

Signal Input

Always use good quality 25 - 35 watt soldering iron. High heat / high wattage soldering iron will harm PCB

as well as components.

Make sure Correct polarity of all Polar Capacitors and Semiconductors.

Securely mount Power Amplifier IC with insulator on suitable Heat sink.

Before powering on for the first time check for any short circuits between power supplies, ground and

output.

Apply power without any output load (Speakers) and input signal connected.

If there is no Bang or Smoke and nothing is getting too hot or burning, Eureka.

Now connect the load ( Speakers ) and power on, there should be no Noise or Hum without input signal, if

there any Noise/ Hum, power down and recheck.

Now apply the Input signal and enjoy

For More information & Support please visit

Blackbuck TDA7265 2.1 Amplifier - List of Components

C4 C6 C7 C14 C16 C17

R1 R2 R9 R10 R11 R12

Note - Connect Subwoofer input Directly to C11.

Instructions

References

C10

C1 C2 C11 C12

C5 C15

C3 C8 C9 C13

R5 R6 R15 R16

R3 R4 R13 R14

R7 R8 R17 R18

D1 D2

U1 U2

JP1 JP2

J6 J7

J2 J8 J9

www.vaspelectronics.com

Quantity Per

Value

4.7nf 100v

100nf 100v

1uf 63v

100uf 50v

470uf 63v

15K

33K

10R

5.1v Zener

TDA7265

wire

SPK L

SPK R

SUBWOOFER

24v

GND

Lin G Rin

PCB