Baumer FLDM 170C1030/S42 Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Caja Baumer FLDM 170C1030/S42. Baumer FLDM 170C1030/S42 44 páginas. Laser copy counter

8.5 Cleaning the front windows

Fingerprints, dust and other forms of dirt on the front window can impair the function of the sensor. It is

normally sufficient to wipe the glass pane dry with a clean (!), soft cloth. Alcohol may be used for heavier

soiling.

9 Setting the operational parameters

Various parameters allow the customer to fully adjust the Scatec-10 / -15 to the specific demands of the

actual application.

Parameter adjusting can be done in the following ways:

 via a PC, an interface, and the application software ScaDiag

 via the CAN-interface (only for Scatec-15)

 via the sensor's key pad and display

Parameter setting via the sensor's key pad and display

The setting of the operational parameters is done within a user's menu, using the four key pads [set], [Esc],

[+], and [–].

The user's menu and the navigation are described in detail in section 10 Display and user menu of this

manual.

The Scatec's operational parameters are all grouped together in menu C.

This section of the manual describes in detail the characteristics of all the operational parameters. The

procedure of how to enter a specific parameter value by means of the key-pad is described in section 10

Display and user menu of this manual.

Note that usually the input has to be unlocked before any operational parameters can be changed.

The unlocking is done by setting setting parameter [B1] to off as follows:

1.)

press [+] until B Locks is shown in the display

2.)

press [set] :

3.)

press [set] :

4.)

press [+] until 0 = off is shown blinking in the display

5.)

keep [set] pressed until blinking stops

Now the input is unlocked and the desired operational parameters can be set in menu C.

The input will be locked again if no key is pressed for 30 minutes.

User manual Scatec-10 / -15

Version 2017-10

the display shows now B1: 1 = on Input lock

1 = on is blinking

www.baumer.com

(consult the Scatec CAN-manual)

12 / 44

(consult the ScaDiag-manual)

(described below)

Baumer Electric AG

Frauenfeld, Switzerland