Comat SMS Relay Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Mando a distancia Comat SMS Relay. Comat SMS Relay 17 páginas. Message system

Comat SMS Relay

SMS Relay Operating Instructions

1.1

The Comat CMS-10 SMS relay is a remote control and messaging system. Six digital inputs

and four relay outputs with alternating contacts are monitored by means of a SMS (Short

Message System) via a mobile telephone network* (SIM card determines the provider). The

device's own phone book saves up to 50 mobile phone numbers of the receivers. Each

status change at the input sends a pre-defined message by SMS to the selected receivers.

The receivers are processed cyclically, according to the order chosen. The outputs can be

switched on and off by means of a pre-defined message by SMS. In order to obtain an

overview of the state of the installation, the input and output status can also be queried by

SMS. The relay outputs have a „time function". The outputs are only switched on during the

preset time. Unauthorised access can be controlled by activation of a password. The SMS

relay sends out a message at regular intervals. The same thing happens if there is a power

loss, whereby the SMS relay sends out a last message. If the power is restored, the CMS 10

sends back a further message. All these options can of course be switched on and off if

required. The programming of the SMS Relay is carried out with the „FAST SMS Set"

programming software that is provided. In this way the settings can be configured

conveniently and easily

*GSM network: 850MHz, 900MHz, 1800MHz, 1900MHz (quad-band GSM module inside)

1.2

1. Switch off the SMS Relay

2. Place the SIM card in the card holder

3. Connect the RS232 interface of your PC or Notebook with the programming

interface of the SMS Relay. Use the programming cable.

4. Now switch on the SMS Relay

5. As soon as the SMS Relay is ready (after about 100 sec), start the programming

software FAST SMS Set ™ (Status-LED and GSM-LED are blinking regularly)

6. Choose your prepared file or create a new file with your configuration. Please set

the correct PIN code.

7. Select a free COM port (Menu Configuration – Select port)

8. Download the file to the SMS Relay (

9. Wait until the SMS Relay is ready again (after about 100 sec)

10. Set the time and the date (Menu Configuration – Set time/date)

Operating instructions SMS Relay

download)

ba_smsrelay_0706e.doc