Amphenol RESMLAC-8MG-CAPS-POE Manual del usuario de hardware - Página 5
Navegue en línea o descargue pdf Manual del usuario de hardware para Interruptor Amphenol RESMLAC-8MG-CAPS-POE. Amphenol RESMLAC-8MG-CAPS-POE 17 páginas. Ip67 rugged ethernet managed switch
Imprimir página
POE
Indications
Section 3
As with any electronic device, you should place the switch where it will not be subject to
Selecting a
extreme temperatures, humidity, or electromagnetic interference that exceeds the
Site
RESMLAC-8MG-CAPS-POE profile. Specifically, the site you select should meet the
following requirements:
CAPS for
The switches are pre-equipped with caps on all ports, including power and Ethernet.
unused
connectors
and prevent from deterioration of the contacts.
The RESMLAC-8MG-CAPS-POE Ethernet Switch can be fastened to any flat surface by
Mounting
mounting the box directly. Refer to the mechanical drawings below. Make sure to allow
enough room to route your Ethernet and power cables.
The RESMLAC-8MG-CAPS-POE weighs 2.2 Kg and is mounted via its four 5.2 mm holes
for screws.
The overall external dimensions of the RESMLAC-8MG-CAPS-POE are 269(L) x 133(W) x
75(H) millimeters.
RESMLAC 8MG CAPS POE - UM
POE
Installation
•
The ambient temperature should be between -45 to +85 degrees Celsius.
•
Surrounding electrical devices should not exceed the electromagnetic field (RFC)
standards for MIL-STD-461E.
Make sure all connectors are protected with cap or sealed plug to ensure sealing
www.amphenol-socapex.com
OFF – No link and No Data
Port number
Orange On – port power is
activated over 2 pairs
Green On – port power is
activated over 4 pairs
Green Blink at 1Hz – Overload
or short circuit is detected on
port output lines
Green Blink at 0.5Hz – A valid
POE load is connected to port
output lines, but PSE has no
sufficient power for supplying
the required load power
rev. 1
Page 5/16
Tel: +33(0)4.50.89.28.00