Amphenol Procom 130000781 Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para Antena Amphenol Procom 130000781. Amphenol Procom 130000781 2 páginas. 2 db mobile glassfix antenna for the 450 mhz band
También para Amphenol Procom 130000781: Manual de inicio rápido (2 páginas)
Imprimir páginaGF 402/...
1. BEFORE INSTALLATION
When selecting mounting location take into consideration: positions of back view mirror,
wiper blade paths and defogger wires (when mounting on rear window). The driver's
view should not be obstructed.
Max. allowed curvature of the glass surface on the mounting spot is 2 mm deflection per
100 mm length.
Environmental- and car temperature must be above 15° C at installation, and surfaces
to be glued must be dry and clean.
2. INSTALLATION
Do not use sealer on rubber gasket or other places.
PROCOM A/S reserves the right to
amend specifications without prior notice
3. AFTER INSTALLATION
Allow the silicone gluings to dry off 2 hours at a temperature above 15° C. To ensure full
strength of the glue, it is recommended to keep the whip off the mount for 24 hours.
4. TUNING INSTALLATION
Insert a forward/reflection-type wattmeter between the transmitter and the antenna.
Key the transmitter and observe the forward and the reflected power.
Adjust the tuning screw on the matching unit until minimum returned power is obtained.
REINSTALLATION KIT
A reinstallation kit including all necessary parts for transfer of the antenna to another vehicle
is available under order No. »GF-RK«.
WARING
SAFETY PRECAUTIONS
Antennas mounted on the windscreen may cause relatively high field strengths in the
passenger cabin and near the dashboard.
1. To prevent health hazard due to RF radiation, persons must not be closer than 30 cm
to the antenna whip (transmitter output power to the matching unit: 20 W). (DIN 57 848).
2. The RF signals at the dashboard may cause interference in the car's electronic
equipment such as broadcast radio, computer automatics, braking systems, electronic
ignition, relays etc. Some cars are more susceptible to disturbances than others. It is the
responsibility of the installer to carry out a thorough check of the proper functioning
under any conditions of such circuits before finishing installation.
The enclosed silicone adhesive contains acetic acid and fungicides. Keep out of reach of
children and dispose properly.
ASSEMBY DETAILS
Page: 2 of 2
Last edited: 2019/08/23