Amphenol Procom GF 151 Guía de inicio rápido - Página 3

Navegue en línea o descargue pdf Guía de inicio rápido para Antena Amphenol Procom GF 151. Amphenol Procom GF 151 4 páginas. 0 db mobile glassfix antenna for the 160 mhz band

Amphenol Procom GF 151 Guía de inicio rápido
GF 151
Do not use sealer on rubber gasket or other places.
3. AFTER INSTALLATION
Allow the silicone gluings to dry off 2 hours at a temperature above 15° C. To ensure full strength of the glue, it is recommended to keep the whip off the mount for 24 hours.
4. TUNING INSTRUCTIONS
Insert a forward/reflection-type wattmeter between the transmitter and the antenna.
Key the transmitter and observe the forward and the reflected power.
Adjust the tuning screw on the matching unit until minimum returned power is obtained.
REINSTALLATION KIT
A reinstallation kit including all necessary parts for transfer of the antenna to another vehicle is available under order No. »GF-RK«.
WARNING
SAFETY PRECAUTIONS
Antennas mounted on the windscreen may cause relatively high field strengths in the passenger cabin and near the dashboard.
1. To prevent health hazard due to RF radiation, persons must not be closer than 30 cm to the antenna whip (transmitter output power to the matching
unit: 20 W). (DIN 57 848).
2. The RF signals at the dashboard may cause interference in the car's electronic equipment such as broadcast radio, computer automatics, braking systems, electronic ignition, relays
etc. Some cars are more susceptible to disturbances than others. It is the responsibility of the installer to carry out a thorough check of the proper functioning under any conditions of
such circuits before finishing installation.
The enclosed silicone adhesive contains acetic acid and fungicides. Keep out of reach of children and dispose properly.
ASSEMBLY DETAILS
Page: 3
Last edited: 2018/11/16