Dahua VTO2202F-P Manual de instalación rápida - Página 2
Navegue en línea o descargue pdf Manual de instalación rápida para Sistema de interfono Dahua VTO2202F-P. Dahua VTO2202F-P 12 páginas. 2mp single outdoor station camera
Imprimir página
HOME SYSTEM CONFIGURATION
When confi guring a home VDP system, all devices should fi rst be connected together. Usually, this is done by connecting both the
camera unit (VTO) and monitor unit (VTH) to the VTNS1060A PoE switch.
The VTNS1060A is a 24v passive PoE unit, this is a different type of PoE than that seen on conventional IP devices. As such, both the
VTO2000A and VTH1550CH can only be used with 24v passive PoE or by connecting a 12/24v DC power supply to the power input
terminals on the units.
Example 1
VTO2202F-P
Module
Example 2
Camera Module
VTO CONNECTIONS
Tamper
Switch
Tamper Switch
Network Connection
+12v
GND
12v Out
Door Button
Door FB
Door NO/NC/COM
RS485 A/B
2
Tel: +44 (0)1457 874 999 | Fax: +44 (0)1457 829 201 | Email: [email protected] | Online: www.cop-eu.com
PoE
Switch
802.3af PoE
PoE
Switch
802.3af PoE
Sounds an alarm in the event that the VTO unit is tampered with
Connect the supplied RJ45 adapter cable to this port
Used when not powering the VTO via PoE, connect the 12v or 24v DC positive supply to this
terminal
Ground connection for 12v DC negative supply and other inputs
DC 12v continuous output for auxiliary device (100mA max)
Input to connect a switch such as a push button for releasing the door lock
Input for door contact to check if the door is closed before engaging lock
Relay output used when unlocking door
RS485 Bus for connecting secondary lock controller DEE1010B
VTNS1060A
Switch
24v PoE
Ethernet Link
VTNS1060A
Switch
24v PoE
Ethernet Link
Connection
VTH Passive PoE Monitor
Main VTH Monitor
Network
Inputs &
Outputs