Amphony 2500 Manual de uso e instalación - Página 8

Navegue en línea o descargue pdf Manual de uso e instalación para Auriculares Amphony 2500. Amphony 2500 13 páginas. 5.8 ghz digital wireless headphones
También para Amphony 2500: Comparación de funciones (1 páginas), Información sobre el producto (4 páginas), Preguntas frecuentes (5 páginas), Especificaciones (4 páginas), Manual de uso e instalación (12 páginas), Manual de solución de problemas (5 páginas)

User and Installation Guide

Step 6

Adjusting the analog audio interface level

This step is only required if the analog audio interface is used.

In order to achieve maximum audio volume at the headphones and maximum

dynamics of the digital transmission and to avoid clipping of the audio, it is

necessary to set the analog audio interface level of the transmitter to correspond

with the maximum audio level of the audio source.

This is done by turning the analog audio interface level control knob which will

change the audio level inside the transmitter before it is converted to digital audio

by the transmitter analog-to-digital converter.

While listening over the headphones, turn the input audio level control knob to the

position that yields maximum loudness of the audio at the headphones without

any clipping (distortion). If the level is set too low, the dynamics of the

transmission are not fully used. If the level is set too high, clipping (distortion) of

the audio will occur.

Listening over headphones at high audio levels can cause

ATTENTION!

hearing impairments! Also, switching between different audio

sources, connecting and disconnecting the transmitter, and

the transmitter going into standby mode can cause loud clicks

and pops which can impair your hearing! Therefore, always set

the volume control to minimum.

Analog audio interface level control

Page 7