Dovpo TOPSIDE Top Fill Squonk Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Cigarrillos electrónicos Dovpo TOPSIDE Top Fill Squonk. Dovpo TOPSIDE Top Fill Squonk 4 páginas.
Imprimir página
START VAPING
1. Install a single 21700/20700/18650 high-drain battery
Make sure the positive and negative ends are facing
the correct directions
2. Power On/Off: Click Fire Button 5 times quickly to turn
the device on, repeat the process to turn the device off.
3. Install the bottle carrier into the device.
4. Attach an atomizer to the device, set your desired
wattage/voltage and start vaping by pressing the Fire
Button.
5. To switch from Wattage Mode to Bypass Mode and
vice versa, hold both Fire Button and "-" Button.
6. Hold both "+" and "-" to LOCK the 'UP' and
'DOWN' buttons, repeat the process to UNLOCK.
SAFETY FEATURES & WARNINGS
1. Battery Reversal Protection
2. Short-circuit Protection: if there is a short circuit,
when you press the Fire Button, the screen will display
"SHORTED".
3. If the resistance of the atomizer is lower than 0.08Ω,
when you press the Fire Button, the screen will display
"LOW Ω"
4. Open-circuit Warning: if there is no atomizer attached
or atomizer has an open circuit, when you press the
Fire Button, the screen will display
5. Overtime Protection: the device will cut power after
10 seconds of continuous firing, screen will display
"OVER 10S"
6. Over-temperature Protection: if the board temperature
goes over 75℃/167°F, the device will cut power,
when you press Fire Button, the screen will display
"TOO HOT".
"CHECK ATOMIZER"