Combi 8600 Series Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Asiento de coche Combi 8600 Series. Combi 8600 Series 9 páginas. Booster car seat

Installing and Removing Seat Back:

To install seat back:

• Place Booster Car Seat base on floor or firm surface.

• Holding seat back slightly reclined, place tabs at bottom of seat back

into slots of seat base

• Rotate seat back upright

• Press down firmly until wings on side of seat back touch arms

on seat base

To remove seat back:

• Place High Back Booster Car Seat on the floor or other firm surface.

• While holding the base down, pull the seat back straight up until it stops,

then rotate seat back into a reclined position and lift out.

Certification

This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards for use in motor

vehicles.

Aircraft Use

This restraint (Booster Car Seat) is NOT certified for aircraft use (see label on car seat).

An aircraft does not have lap and shoulder belt systems required to use with Booster Car Seats.

Car seat parts can get very hot in the sun or warm weather.

To avoid burns, always check before putting child in car seat.

Protect vehicle seat. Use a thin car seat mat, thin towel, or thin blanket under and behind car seat.

Store instruction manual under seat pad.

DO NOT use after 7 years from date of manufacture on label.

Section 9 - Seat Back Assembly

(fig. a).

Section 10 - Additional Information

Seat

Back

Wings

(fig. a)

Base

Top Of

Arms