Combi-Camp minik 10 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Cerraduras Combi-Camp minik 10. Combi-Camp minik 10 13 páginas.

MAINTENANCE:

- Clean front of lock with a mild damp cloth with detergent if needed.

- Do not use any hard or scratching cleanser.

- Do not clean with chemical materials that melt plastic (thinner, acetone, etc.)

- Be careful not to spill water on lock.

- Read manual before using lock.

- Periodically check nuts and screws to be tightened.

- Do not over-tighten nuts or screws. Do not use an electric screw gun

during installation unless equipped with a torque adjuster.The maximum

torque on the cylinder screw is 25Nm.

- Set and test user and master passwords prior to installing the lock

- Change all default passwords with your own passwords.

- Common sense, but we must say it... Do not keep the passwords in

the cabinet where the lock is being installed!

- It is not possible to open lock if installed and you forget the user and

master password.

- Lock gives a warning beep when incorrect passwords have been

entered in repeatedly.

- Not possible for front side of lock to be opened by breaking or trying

to force open lock.

- Use CR2450 3.0V Lithium batteries.

- Remember that battery consumption is high when programs 2, 3, and

7 are active.

- Two cams are included-

- Cams can be placed at

increments of 90 degrees

- The Stop Cam (#4) in

installation instructions

can be positioned for turning

the cam clockwise or counter-clockwise

Battery failure override- The miniK 10 has 2 external nodes surrounding the

red and green indicator lights where an external battery can be connected

long enough to enter in the correct code to open the lock allowing new batteries

to be installed. For more detailed instructions, go to www.combi-cam.com/E/

7/8" Straight Cam

Cam

22mm

Placement

1-1/2" Straight Cam

38mm

Page 9